Need Help! Haas VF Table Pins - CNCzone.com-The Largest Machinist Community on the net!

larkidav · #1 03-30-2008, 05:40 AM

Just joined this morning.

Queestion: Haas has 0.828"/21mm holes in VF table. Does anyone know of a company that produces pins for these holes or do you just make them yourself?

Thanks, Dave L

61SedanMan · #2 03-30-2008, 08:10 AM

Why would you pay Haas to make something that you could, provided that you have any degree of lathe?

What do you plan to use them for out of curiosity?

larkidav · #3 03-30-2008, 10:04 AM

Can make pins on lathe; not a problem. But it will cost the customer more if I make them, than he would pay if I purchased them. So does anyone have a vendor for these pins.

Thanks, Dave L.

PBMW · #4 03-30-2008, 11:08 AM

Buy metric tooling pins, I would imagine any tool store could get them for you.
Or J&L
Or MSC
Or McMaster

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Haas Servo Rotary Table	Dennis Tillman	Servo Motors and Drives	10	02-21-2008 10:13 PM
Popup pins	Adam M.	Work Fixtures and Hold-Down Solutions	0	01-15-2008 08:43 PM
Haas stepper rotary table question...	cabledude	Stepper Motors and Drives	0	12-11-2007 04:29 PM
Converting a Haas stepper rotary table?	cabledude	Haas Mills	0	11-24-2007 03:30 PM
Haas rotary table on vertical Hitachi Seiki	smoggy	Haas Mills	0	05-18-2005 12:57 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)