Debug - CNCzone.com-The Largest Machinist Community on the net!

Fido57 · #1 02-23-2008, 12:36 PM

Hey guys. Just replaced a spindle belt on a Vector drive. Book says to look up encoder value in "Debug". Where the heck is debug? Thanks.

pit202 · #2 02-23-2008, 01:16 PM

debug is a service entry if you`re on help screen type "debug" you`re in debug mode , if you are searching for spindle encoder steps just pg_up / pg_dn in posit screen or currents and commands.

serviceman · #3 02-24-2008, 07:15 AM

setting 7 off push alarm type debug fo to posit page and page up to pos raw dat in the middle of the screen not labelled turn the spindle you will see the number change

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
PICStep V4 (or how to not have to debug your own BOB but use someone elses!)	Garfield2	PicStep Controllers	2	10-08-2011 09:43 AM
Help needed to Debug G41 G42 problem	Al_The_Man	General CAM Discussion	4	07-05-2004 06:22 PM
Servo motor and encoder. How to debug?	ESjaavik	Servo Motors and Drives	6	06-20-2004 05:37 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)