TM 1 - service - CNCzone.com-The Largest Machinist Community on the net!

f1jdm · #1 01-23-2008, 10:03 AM

I have a 2000 TM 1 which has run flawless since purchase and I'm just starting to experience some small issues with, which I can live with. I have kept machine clean and lubed since day one. Is there any other service that I need to be doing, or any maintanence procedures that I should look into before I have some major issues. (ex. backlash adj. , way wipers replaced )
Any suggestions would be appreciated.

Thanks

SORCHEROR · #2 01-23-2008, 10:25 AM

the only thing that i do is when i clean the machine i wipe the linear guide ways clean,and i always try to keep chips from building up on them,the most important is lube
grease is cheap,thats my moto

JoBwan · #3 01-23-2008, 01:59 PM

f1jdm,
Keep all of your axial fans clean and make sure that thay are running. Heat is the # ONE problem with electronic failures.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Great Company- Great Service!!!!	Smitty911	Vendor Discussion	7	02-05-2008 05:05 PM
IH in Commercial Service	bumperscoot	Industrial Hobbies (Support forum)	2	04-08-2007 04:00 PM
provide CAM service.	eivendai	Employment Opportunity	28	04-15-2006 10:17 AM
Discovery 300 needs service in WI	scnolan14	Bridgeport and Hardinge Mills	6	02-22-2006 01:44 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)