| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Haas Mills Discuss Haas machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-12-2007, 10:14 PM
| |||
| |||
I just replaced spindle drive in a 1994 vf2  and now I am getting a servos off and spindle drive failure alarm. What do I have to do to get rid of this? I am getting a solid color er3 on the spindle drive it self. That says that there is a circuit opened or closed that should not be. I am clueless please help.    |
|
#2
08-13-2007, 08:31 AM
| |||
| |||
| 070813-0722 EST USA duckslayer: I am assuming you are refering to the electronics that powers the spindle motor. Is this a Magnetek variable frequency Spindle Drive Controller ? If so, then go to this thread for some background www.cnczone.com/forums/showthread.php?t=22019 From where did you get the replacement unit, and is it an identical unit? If so, then were you very careful to mark the wires before removal of the orignal, and get them correctly located on the new unit? . |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Shoptask lath drive train replacement | kb7vms | Shopmaster/Shoptask | 2 | 05-09-2007 12:17 AM |
| Spindle Motor replacement? | Trapper14 | Mini Lathe | 3 | 03-10-2006 05:48 PM |
| Looking for Ideas on Replacement Spindle. | Willyb | Benchtop Machines | 2 | 09-13-2005 01:22 PM |
| Automatic replacement spindle | Dag-50 | Mechanical Calculations/Engineering Design | 5 | 03-31-2005 04:04 PM |
| Brushed servo drive replacement | motordude | General Electronics Discussion | 3 | 07-06-2004 02:09 PM |
| | |
Linear Mode
