| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Haas Mills Discuss Haas machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-01-2007, 12:46 PM
| |||
| |||
I was machining a part on our Vf-2 yesterday and everything was going finr then when it went to do the finish pass and alarm came up and said "cutter compensation interference" #367. what does this mean? is there a problem with our new machine or is there a problem with the programmer(me)?  |
|
#2
02-01-2007, 01:21 PM
| |||
| |||
| My VF book sez that the G01 can not be done with cutter size. Therefore I gotta think that you are using comp in the control and inputting a dia in the geometry page and that the G01 value at your lead in is less than teh radius of the tool. Personaly I use wear comp so that I don't put a value in the dia on the geo page and when I comp it's a +or - small number. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Amp Alarm | bbrreid | General Electronics Discussion | 4 | 02-29-2012 05:13 PM |
| 205 p/s alarm | bink | Fanuc | 0 | 12-08-2006 09:04 PM |
| alarm #180 | j-radkemachine | Haas Mills | 1 | 07-20-2006 01:34 PM |
| Ps-012 Alarm For T15 | Mircea | G-Code Programing | 12 | 06-14-2006 11:01 PM |
| Alarm 160 | quatturbo | Haas Mills | 4 | 02-26-2006 12:27 PM |
| | |
Linear Mode
