| | |
I have just purchased a used HRT 210 it works great, however I am makeing diamond lead screws and my table rotated a total of 7200 degrees, after I am finished with the thread I home the Table (G91 G28 A0) and it seems to have to unwind that entire 7200 degree rotation. Is there a way to set a parameter or something of this nature so the table can find its home in a single rotation?
IIRC, someone mentioned that there is a setting, #108 for "quick rotary G28".
I don't think I've tried it since I heard about it to know if there are any more details to add about how to use it.
First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Posting Permissions
| | |
LinkBack URL
About LinkBacks
