DXF Pictures for engraving?

[ghyman]

I am not sure this is the correct forum for this question, so my apologies if not.

Our company is having an open house tomorrow, and I'm looking for some DXF files of cartoon characters or other such "kid friendly" pictures to use for milling some small tokens... nothing real fancy, just showing off the machines' capabilities and making kids smile.

Anyone know of any pictures I can use?

Thanks!

[ChrisJ]

Well, if you don't get any better replies than this, here you go. An image of Mickey M. that was traced in OneCNC. I cleaned it up a little, it may need a little more.

Chris

[ghyman]

That's perfect!

Thanks a million!

I just hope Disney doesn't sue...

[smoregrava]

check out the thread "share you files part or art" Here there is a lot of fun stuff

Share Your Files Part or Art

Or maybe this was to late