Slow TL-1

[Edster]

I read the post about increasing the spindle speed on a TM-1. Has anyone played around with the TL-1 spindle speed settings?

[lakeside]

If this is a new machine and you change any setting don't forget to change it back before you ever have Haas in shop. Warrantee will be voided by changing anything also would suggested responds be off line with machine data bits yes there a code and good luck finding it

[Edster]

Thanks for the tip, I would only change the settings if I needed to go a little faster for a job then change them back. 1800 is a little slow. I'd like 3000 but would settle for 2500. The post about the TM-1 has the settings listed that need to be played with. Max Rpm and Max Frequency. I'm just wondering if anyone was brave enough to try it on their TL-1.