Mastercam 7 portprocessor for Haas

[Goldeneaglemfg.]

Hey guys, I am about to get a couple of Haas machines, specifically a small SL-10 and a VF-3. Right now I use version 7.2 Mastercam and I needed to know if there is a post processor available for this control. I know that right now I have a couple of Fanuc 6, 9 and 11 and a Siemen 810 control that need tweaking out of the current post I am using and I wanted to know if there is a specific post processor that will enable less editing of the program before sending it to the machine? Any info or pointing in the right direction will be greatly appreciated! Thanks guys.

[PBMW]

Most any fanuc post will work just fine
My haas does not use G95's so you may need to tweek the post to use IPM feeds but that's just about the only thing that would need adjusting
Jim

[cadcam]

There is a post for the Haas Mill on the old V7 and as for the Lathe use the stock MPLfan being a Fanuc post and tweek it closer or talk with your dealer to tweak the post for you.

[smi4motion]

We use the Generic Fanuc one that come with the program for our HAAS mach's.