cat40 haas

[Delw]

would anyone that has a newer 2008-2010 cat 40 machine mind measuring the distance between the top of the flat on the tool holder to the bottom of the spindle when the tool is in the spindle?
I am looking for that Approx. distance. I know its late but if anyone is working nights and bored slide a pin in there or see if a 3/16 pin goes in or doesnt.
I'm working late and bored sooooo LMAO

I am using kenemetal tool holders so that Might make a difference I have no clue.

I just had a thought and will contact haas tomorrow for the dimension if no one has it avail.

Thank
Delw

[JWH]

Using gage blocks I get .193

JWH