Help Me Find A Haas - TM1 or TM2

[KylieandDany]

Greetings all. A good friend of mine is looking for a TM-1 or TM-2.
He has been dealing with a machine broker (for about two months now) with no luck so far. Each "great" machine that the broker finds, never materializes. I'm looking for anyone out there, looking to sell, or knows of someone else who wants to sell, their toolroom mill. As long as the machine is in good shape, he's ready to purchase - today. He's looking for a machine with 6000 spindle hours or less, 2004 or newer. And it will need to pass a ball-bar test. At this point, I doubt he'll want to deal with a machine reseller, so I'm looking for a private party. If you send me your info, I'll pass it on to him.

Thanks.

JS

[ReliableJen]

Is your friend still looking for a HaasTM-1? I have a 2002 for sale with only 1600 hours.

[KylieandDany]

He did find one, but now I'm looking another one. How much would you like for it?

JS

[KylieandDany]

And where are you located?

JS

[ReliableJen]

The Haas is in Frederick, CO. It was in a prototype shop and is SUPER CLEAN. We are asking $24k. I just got it yesterday and just listed it on machinetools.com I just happened to be searching for something about the specs and I saw your thread.

[KylieandDany]

Yes, please send pictures, and a list of options (if any) that are installed.
Thanks much,

JS

[ReliableJen]

SPECS: Table Size: 47.75" x 10.5", Max Table Load: 3,000 LBS, X Axis Travel: 30", Y Axis Travel: 12", Z Axis Travel: 16", Spindle Taper: CAT 40, Spindle Speed: 4,000 RPM, Spindle Motor: 7.5 HP, Rapid Traverse Rates: 300 IPM, Cutting Feed Rates: 200 IPM, Machine Weight: 3,000 LBS &10 STATION ATC.
Power On: 10,569hrs, Cycle Start Time: 2,139hrs & Feed Cutting Time: 1,699hrs.

I attached a picture!

[ReliableJen]

If you can message me your email. I can send you all the pics. It won't allow it on here. The files are too large.

[gizmo_454]

... Power On: 10,569hrs, Cycle Start Time: 2,139hrs & Feed Cutting Time: 1,699hrs.

Be careful of machinery dealers posting these kind of times about Haas machines for sale! Most of the time, they take these times right off of the Current Commands page showing the 3 above times along with M30 counts. All of the numbers on this page can be reset using the origin button on the control and may NOT be an accurate representation of the ACTUAL machine hours. To find ACTUAL times, you have to look on one of the Diagnostic pages.

Good luck in your searching.

Mike

[ReliableJen]

I agree that's why I send all of them de-bug instructions to get the actual hours.