Lost all my programs

[greenweanie]

One of my guys erased every porgram on our VF6. I have a 4th axis and Renishaw OMP-40 probe. I am trying to get the basic programs back on there.
I have a spindle warm-up (2020) program,
and Spindle Run-in (2021), and a basic engraving program.
Does anyone have one that turns the probe off? or anyhting else i might need? My back-up disc is unreadable.

[haastec]

One of my guys erased every porgram on our VF6. I have a 4th axis and Renishaw OMP-40 probe. I am trying to get the basic programs back on there.
I have a spindle warm-up (2020) program,
and Spindle Run-in (2021), and a basic engraving program.
Does anyone have one that turns the probe off? or anyhting else i might need? My back-up disc is unreadable.

Check to see if setting 23 is on or off. This setting, when on, hides all of the 9000 series programs which will keep them from getting erased. All of the Renishaw programs are in the 9000 series. If it is off, then sorry, they are gone.

Is the disk unreadable at the machine, pc or both. If only one, check the other.

Good luck!

[greenweanie]

It is unreadable at both. I hate dealing with 3.5 diskettes.

[txcncman]

Call Haas with you model and serial number. They might charge you, but they should have the original set up config for your machine on file.

[greenweanie]

I cleaned my disc drive and wiggled it around until it read it. Made a copy and reloaded the main stuff back on the machine... thanks for al your help.