Good Morning all!!
I turned on my 2000 haas vf-2 this morning and the screen only shows one line---03A028EA 0020
The machine wont do anything and i cant erase/reset/cancel
I tried powering it completly off with the switch in the back and the line changed to 03A000F8 0020
Please help if anybody knows what my machines problem is.
Thanks
Phone Haas tech support. But I'd have to wonder if it is indicative of a bad memory chip, assuming the machine does some sort of memory check on startup.
First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Try holding down the "PRGRM/CONVRS" button and power on the machine. Tell us what you get.
These messages are an indication of a software/hardware failure, there is no "soft" recovery from this condition. Please contact your local HFO for support:
HFO-Denver
A Division of Moncktons Machine Tools
637 Osage Street
Denver, CO 80204
Phone: (303) 571-4933
E-mail Address: mmt@mmtdenver.com
Thanks,
Ken Foulks
Posting Permissions
LinkBack URL
About LinkBacks
