Need wiring diagram of Haas HRT 160 4th axis

[PEU]

The cable that goes from the control to the 4th axis unit is giving a fault error, I want to test continuity but I don't have the wiring diagram, is not provided in the operator manual, this is the connector:



I would like to know what goes where from this connector to the square box on the top side of the 4th axis unit.

Any help will be really appreciated, you know what downtime cost these days...

Thanks!!

[PEU]

no one?

[Wizzard of H]

This is a brush rotary table.
Problems are not in the connector.
Most frequent failure is breaks in the cable.
Next most likely is coolant getting into enclosure with motor.
Knowing the alarm you get helps.
Pinout at 17 pin connector is:
L R +5 v
K R/wh logic gnd
A Br/wh A
B y/wh B
C or/wh Z
M br /A
N y /B
P Or /Z
T bl overheat sw ref logic gnd
D bl/wh home sw ref +5/logic gnd

E & F wh motor +
J & H bl motor –

G gr/y earth gnd

R 115 VAC air solenoid
S 115 VAC air solenoid

[PEU]

Thanks a TON !!

will check the cables and write down the alarm codes.