Results 1 to 3 of 3

Thread: need help

  1. #1
    Registered
    Join Date
    Oct 2010
    Location
    USA
    Posts
    9
    Downloads
    0
    Uploads
    0

    need help

    Hello I need help I 'm trying to put back together my hrt-210 and I cant figure out where the o-ring goes on the back of the slotted face plate cant get it back on again thank you.


  2. #2
    Registered
    Join Date
    Jan 2008
    Location
    usa
    Posts
    181
    Downloads
    0
    Uploads
    0
    it goes around the outside of the face plate
    Just push the button,what's the worst that could happen.


  3. #3
    Registered
    Join Date
    Oct 2010
    Location
    USA
    Posts
    9
    Downloads
    0
    Uploads
    0
    thank you fuzzyracing oring was so small just didnt look like a fit but it worked.


Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.