Need Help!- Best BobCad Post Processor for Haas Mini??

[LockTech]

Just purchased BobCadv24 and a new Haas Mini. I was looking at the list of post processors and wanted to see what someone who already has this setup recommends?

Thanks
Keith

[jalessi]

Keith,

Bobcad will provide you with the correct post processor free of charge.
Give them a call Monday.

Jeff...

[LockTech]

Ya, I knew they would...was just hoping to start playing with it a bit over the weekend.

[jvangelder]

i would imagin a generic fanuc o post should get you started.

[LockTech]

Thanks will give that one a try too. I see two HAAS pp's on the list, one for VF machines and one for TM machines and wasnt really sure which one a mini would be classified as.

[RevEdo]

Mini used to be classified in the TM category when we first started selling them, but I'd dtart off trying the VF pp.

[LockTech]

Thanks for the input everyone,

As it turns out, they both work fine, not sure what the initial issue was with it when I initially tried it. The Fanuc0 works as well but the table rests in a different place when the program finishes running.

On a side note, TM and VF both worked the ATC with no problems