Regrinding Endmills, need a vendor!!!

[gixxergary]

I have a ton of 1/2 and 3/8 carbide endmills, that are just worn on the bottom 1/8 to 1/4 inch. The rest of the cutters are still new and unused. Im looking for a (GOOD) tool grinding shop to freshen these up for me. Normally, we just put them into a box, and grab a new tool for our jobs, but its time to get them re-done.

Can anyone give me a lead on a trustworthy source for this. No diameters to be ground, just the ends to square corners.

Thanks in advance for your replies,

Gary

p.s.,
No, we dont have time to do these ourselves, even though we do have the fixtures.

[jvangelder]

Location? I use a local small regrinder who has always done good by us

Located in southern NH