| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Haas Mills Discuss Haas machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-22-2005, 06:48 PM
| |||
| |||
| Alarm 107 at start up We have a VF4 2001 with a dual pallett changer The alarm states; Emergency stop button was pressed. After the E-stop is released, the reset button must be pressed once to correct this to clear the E-stop alarm. This alarm will also be generated if there is a low pressure condition in the hydraulic counterbalance system. In this case, the alarm will not reset untill the condition has been corrected. I've tried the reset to no avail, also checked resitance on the E-stop, its good. Is the hydraulic counterbalance the fluid that is in the spindle transmission compartment or does it have to do with the nitrogen counterbalance located in the back?    |
|
#2
07-22-2005, 08:18 PM
| ||||
| ||||
| "nitrogen counterbalance located in the back'" That would be it. Nothing to do with spindle or gearbox.
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
