Servo Is On warning ? - CNCzone.com-The Largest Machinist Community on the net!

Ken_Shea · #1 01-05-2011, 10:20 PM

When attempting to change parameter 57 bit 7 to 1, it fails to input the number and flags "Servo Is On"

Any ideas on that.

All else seems to operate normally.

Ken

Geof · #2 01-05-2011, 11:07 PM

To change Parameters you have to turn Setting 7 OFF and press the E-Stop button.

Ken_Shea · #3 01-05-2011, 11:11 PM

Originally Posted by Geof

To change Parameters you have to turn Setting 7 OFF and press the E-Stop button.

Had it unlocked but totally forgot about the E-Stop.

Thanks much

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
MC x3 Warning	jimmiethekid	Mastercam	2	05-12-2010 11:03 PM
ShopCam Warning !!	routerman	Shopsabre	11	11-25-2009 05:11 PM
W05 WARNING FEEDRATE	guydrisc	Okuma	4	06-15-2009 10:28 PM
Dump Warning	Mariss Freimanis	Suggestions for the CNCzone.com site.	13	07-04-2008 01:12 PM
Warning!	andy.f	General Metalwork Discussion	2	01-25-2008 09:38 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)