maintenance mode? - CNCzone.com-The Largest Machinist Community on the net!

kwhite2 · #1 12-15-2010, 01:21 PM

anyone know of any type of maintenance mode on mini mill, trying to one step it thru tool changer, having some issues with it hanging up sometimes, trying to clean it out etc....thanks

dcoupar · #2 12-15-2010, 02:37 PM

It's been a while, but IIRC, you used to be able to hit Feed Hold while Z was moving up and it would wait until you pressed Cycle Start again. That's how we cleaned the tool changer in the "old days".

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bridgeport Interact 2 -- tachometer mode vs. voltage mode?	ichudov	Bridgeport and Hardinge Mills	2	06-28-2010 01:24 PM
New Machine Build- spline mode nurbs mode	cooltool	CamSoft Products	4	03-10-2009 02:03 AM
What is - Torque Mode? Position Mode? Speed/Velocity Mode?	sunmix	Servo Motors and Drives	25	10-26-2008 03:53 AM
CNC Maintenance	shinerbttu	Employment Opportunity	0	05-17-2006 10:50 AM
R2E4 Maintenance Mode Password?	arsenix	Bridgeport and Hardinge Mills	8	01-31-2006 08:02 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)