11-22-2010, 12:27 PM
|
| | | Join Date: Jun 2010 Location: united kingdom
Posts: 13
| |
hi i have a problem with using a macro i wish to realign some slots on some round parts using a macro rotating the g68 in the "Y" plane i can get it to measure one face and right the macro but im not sure how to do it
on two planes and correcting the error in the macro i have used the code as per example any help would be very gratefull i have a super mini mill with the rotating and scaling switched on i also ran a simple macro probing the bore which works fine from the vqc
G00 x5.5 YO
G00 Z-1.5
G65 P9023 Y4.125
G0 G91 X11. Y0
G65 P9023 A7. Y4.125
G68 G90 Y0.R#144 |
Linear Mode
