Problem Haas VF-1 2007 - CNCzone.com-The Largest Machinist Community on the net!

tsrnewlin · #1 11-12-2010, 07:58 AM

Currently having tool changer problems due to the Carousel will move to change out the tool from the spindle okay. However the tool carousel begins to back away from spindle ever slow slightly, but enough that it becomes out of alignment with the spindle. Why is the carousel moving back?

Geof · #2 11-12-2010, 10:32 AM

When the carousel moves in a pin sliding in a slot opens the door, you can see it on the top. If there are chips in this slot they will compress as everything moves forward then act like a spring and push things slightly back as soon as the shuttle drive motor turns off. Check that everything is clear of chips.

haastec · #3 11-12-2010, 12:01 PM

Check your motor brushes also. Carefully blow out any dust in the motor with the brushes out.

tsrnewlin · #4 11-17-2010, 08:08 AM

Thanks for the helpful information, issue was chips compressing causing the carousel to move back. WOW this forum and the people involved are terrific.
Thanks again.

Geof · #5 11-17-2010, 08:29 AM

Originally Posted by tsrnewlin

...... WOW this forum and the people involved are terrific.
Thanks again.

Aw shucks, it's nothing.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- help whit post processor for haas sl30 in sprit 2007	HAASESTUDENT	Esprit	0	04-20-2009 05:42 PM
Haas SL-20,2007 tolerence issue help	mkmk123	Haas Lathes	4	11-21-2007 03:16 PM
Sc 2007	Mickey_D	SprutCAM	0	10-26-2007 05:25 PM
V20 - 2007	Redwon	BobCad-Cam	6	09-10-2007 10:19 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)