Possible to add parts catcher to 2006 SL10 without one?

[locash]

*Crap, posted in the mill section instead of the lathe, moderator please move*

I bought a late 06 SL10 brand new, and instead of buying the parts catcher option, I bought the tailstock (which I have never used) and the worthless chip auger/parts smasher (which is now sitting on the floor instead of in the machine).

I see that there is a bolted in plate on the outside of the machine where the parts would end up after being caught. Obviously a question for my HFO, but is there a "kit" I can buy to add the parts catcher option?

I recently bought ethernet/hard drive boards for both my mill and my lathe from ebay and they work perfectly (and were only about $650 each, compared to the $3000 that the HFO wanted), and also added the Pcool option to my VF2 for under $300 (once again, an ebay purchase), and I am getting sick of digging all my parts out of the chip pile in the lathe, so it made me wonder..

[GermanTec]

Yes, there is a kit for the parts catcher option. I don't know the correctly price in US $ but is nearly 2000€. on a SL-10 You can install the option by yourself or you can call and pay a Tech for 1-2 hours.

[KenFoulks]

The Haas factory field install kit is 93-0371.

[locash]

You are correct on the part number, and it is $2595.00 US, a bit too much for my taste, perhaps it is time to build one..