| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Haas Mills Discuss Haas machinery here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-12-2010, 11:51 AM
| |||
| |||
I have an old bridgeport 4th axis, and a 2000 vf-8 with the fourth axis option wired up for a brush motor. I was wondering if it was possible to wire up the servo to the fourth axis wiring on the haas. The servo on the rotary has a 16 pin connector, where the haas has a 17 pin. i've heard of the haas cable adaptor from 17 pin to 14 pin but not a 16 to 17. Any ideas?  |
|
#2
05-12-2010, 04:59 PM
| |||
| |||
| I could be wrong but I think it would only work if you had a bridgeport control box too (if bridgeport do one). I would suggest you sell your 4th axis and buy a used Haas one instead - you will probably find some on e-bay: http://cgi.ebay.co.uk/97-HAAS-HRT160...item2306e6ca47 This one has a rotary control box which you don't really need - but i'm sure you could find one without the control box which would be cheaper! Hope this helps. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bridgeport Z axis? | jjh122 | Bridgeport and Hardinge Mills | 25 | 10-31-2009 08:39 PM |
| bridgeport z axis oiling | CNCPrototype | Bridgeport and Hardinge Mills | 8 | 11-16-2007 09:21 AM |
| Bridgeport (look alike) Z axis | andrewbishop66 | Bridgeport and Hardinge Mills | 3 | 03-01-2007 04:23 PM |
| Bridgeport Z Axis | kewl_cat | Bridgeport and Hardinge Mills | 4 | 04-21-2006 08:39 AM |
| 5 axis bridgeport | JIMMY | DIY-CNC Router Table Machines | 2 | 12-15-2004 11:48 PM |
| | |
Linear Mode
