lathe turret adjustment/alignment help!!! - CNCzone.com-The Largest Machinist Community on the net!

06-28-2009, 09:24 AM

thum31

Join Date: Jun 2008

Location: us

Posts: 18

lathe turret adjustment/alignment help!!!

Had a turret crash. Hit the wrong button and spun the turret backwards
into a 1" piece of aluminum. at first it would not seat properly, I tried the things listed in the manual and finally after a big pop the turret would seat. Now it chirps at every tool change and the tool center is about 1/4" low.

How do you make this adjustment, and how hard is it to rebuild the turret. Now there is part of a o-ring hanging out behind the turret.

this is a haas hl-2

thanks

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
need help with turret alignment	wonder	Calibration & Measurement	0	07-25-2008 05:37 PM
Problem- Okuma Lathe Turret Alignment	herotool	Okuma	11	06-17-2008 11:51 AM
turret servo adjustment.....	theemudracer	Fanuc	1	05-16-2008 12:39 PM
sl-30 turret alignment	bowhunter	Haas Lathes	12	12-05-2007 09:49 PM

All times are GMT -5. The time now is 08:38 AM.