HL-2 startup help - CNCzone.com-The Largest Machinist Community on the net!

thum31 · #1 06-02-2009, 11:56 PM

I just purchased a used hl-2. Got it hooked up today and I get a couple alerts, 102 servo stop and 107 emergency stop. the book says it could be from the e-stop and to hit reset 2 times.
No matter what I do I can't get these to clear. I think it will be something small but I don't have a clue.
Any help on getting this running would be GREAT!

Geof · #2 06-03-2009, 12:15 AM

Did you release the e-stop nutton by giving it a twist clockwise; it locks on when it is pushed.

thum31 · #3 06-03-2009, 07:53 AM

Yes, I wonder if they could have changed something before they shipped it. It also says "unclamped".

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Buy a New VMC for StartUp	sdb3dnc	General Business Practices and Pricing	3	04-23-2008 04:54 PM
New VMC for New StartUp	sdb3dnc	Want To Buy...Need help!	7	04-11-2008 09:44 AM
no startup	markjb	Fadal	5	03-12-2008 01:26 PM
Need startup hints - day 1	designerpatrick	Milltronics	6	11-21-2007 10:23 AM
mm on startup?	bigz1	Mach Mill	2	05-20-2007 06:44 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)