| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Haas Lathes Discuss Haas lathe here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-22-2009, 01:46 PM
| |||
| |||
Cnc noob here. I went to an auction recently and was looking at a very clean Haas SL20T. I punched up Current Cmds and paged down to see 690 for spindle hours. Cool. I did not see how it was done but someone else brought up a screen that had the header: "POS-RAW DAT 2 (MEM)" and the screen showed 4259 hours. Not Cool. Can someone explain what's going on here?? Regards, Jim  |
|
#2
01-22-2009, 04:36 PM
| |||
| |||
|
__________________ An open mind is a virtue...so long as all the common sense has not leaked out. |
|
#3
01-27-2009, 04:46 PM
| |||
| |||
Thanks Geoff Regards, Jim |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HOURS | Sprew | Haas Lathes | 5 | 07-07-2008 01:50 PM |
| CNC Hours? | end-mill | Haas Mills | 3 | 09-04-2007 09:38 PM |
| On time Hours | smittys800 | Haas Mills | 5 | 08-26-2007 11:56 PM |
| how many hours is a lot? | 1ctoolfool | Haas Mills | 2 | 04-30-2007 05:34 AM |
| How do you tell hours on haas vfo? | turboboy | Haas Mills | 5 | 10-30-2006 04:37 PM |
| | |
Linear Mode
