Milling G02/G03 on O.D. with TL25 - CNCzone.com-The Largest Machinist Community on the net!

vicstransam · #1 01-07-2009, 09:23 PM

Tried to mill a key slot on O.D. with a radius at start of key slot and the control just ignored the G02 and just milled it with no radius, so we had to program a chamfer by estimating a C start position for the chamfer and it worked well. Is it possible to program a radius using G02/G03 on the O.D.? Is it possible to mill a circle or letter "O" on the O.D.? The programming manual only shows examples of milling on the face not the O.D.

CNCRim · #2 01-08-2009, 04:38 PM

Is it TL25 lathe? post ur program on here we might see something. It's hard to understand... without see the program itself.
Second, is your machine has Y?

MikeOD · #3 01-08-2009, 09:05 PM

Originally Posted by newtexas2006

Is it TL25 lathe? post ur program on here we might see something. It's hard to understand... without see the program itself.
Second, is your machine has Y?

Haas has never sold a lathe with a Y axis.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- TL25 Haas Lathe active tooling	alphamoose	General Metal Working Machines	1	09-19-2008 05:02 AM
Milling with bottom vs milling with side?	REVCAM_Bob	CNCzone Club House	13	06-30-2008 09:23 AM
RFQ little milling job	gazmalman	Employment Opportunity	6	01-20-2008 06:24 AM
tl25 sub chuck help	mkmk123	Haas Lathes	0	11-11-2007 04:52 PM
New to milling	Marlboro	Benchtop Machines	3	08-23-2004 12:37 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)