Problem sl-30 tailstock - CNCzone.com-The Largest Machinist Community on the net!

11-04-2008, 10:32 AM

travis1

Join Date: Aug 2007

Location: us

Posts: 12

sl-30 tailstock

permalink

i dont think mine is rite not sure but i think i need to swap the coil wires so any who this is whats going on ive got the 2 stage on the retract it pulls back @200 psi slows to 100psi and holds @165psi advance is @200psi with no slow down

105 set @ -10.000 stops @ -11.000
106 set @ -18.4 this should be -18.1
107 is @ -1.0

any one ever seen this

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Little extra help for tailstock	bdyenter	Daewoo/Doosan	0	10-17-2007 10:24 PM
tailstock won't extend	burnin daylight	General CNC (Mill and Lathe) Control Software (NC)	0	03-19-2007 08:54 PM
tailstock won't extend	burnin daylight	Daewoo/Doosan	0	03-19-2007 03:35 PM
Right pressure for tailstock	jani	General Metalwork Discussion	12	03-05-2007 10:45 AM
TL-2 tailstock	rbest27	Haas Mills	2	11-10-2006 05:20 PM

All times are GMT -5. The time now is 03:54 PM.