Newbie ... hmm - CNCzone.com-The Largest Machinist Community on the net!

fokusco · #1 06-20-2008, 07:19 AM

Trying to figure out sl-10... Only have x and y axis... set my part offsets, enter MDI mode and program X0 Y0 and it sets an alarm off saying "V axis disabled"... I have no v axis. WTF?

PBMW · #2 06-20-2008, 07:38 AM

Yes you do....
The V axis is the barfeed.
Look to see if you have it turned on in the parameters and the cable not plugged in....

pit202 · #3 06-20-2008, 01:12 PM

normaly on lathes you have x and z axis , maybe this is the reason ?

Geof · #4 06-20-2008, 01:26 PM

Originally Posted by fokusco

Trying to figure out sl-10... Only have x and y axis... set my part offsets, enter MDI mode and program X0 Y0 and it sets an alarm off saying "V axis disabled"... I have no v axis. WTF?

As pit202 says, you have no Y axis.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)