G41/G42 callout before G71

[NV529]

On the haas control can I call up G41/42 prior to starting the G71 cycle? our machines are set to "fanuc" setting BTW.

(ROUGH TURN)
G42 G00 X1.0 Z.05
G71 P1 Q2 U.010 W.005 D.05 F0.015
N1 G00 X... Z...
...
...
...
N2 G01 X1.0
G40 G00 X1.1 Z.10

[gizmo_454]

No. Normally that is done in your "N1" line directly after the "G71" line. Just don't forget to turn it off in you "N2" line.

Mike