Originally Posted by
martingandara
A few days ago I updated the mill software of a VF-2 from 16.05 to 16.11A.
When the machine had the old software, the machine asked for the spindle warm up every 4 days o when the machine needed the warm up. Now with the new software 16.11A, everytime I turn on the machine, it asks for the spindle warm up. If I turn off the machine and one minute later I turn it on again, it asks for the spindle warm up.
Is there any way to change this?
I would like that the machine asks for the spindle warmup just when it is necesary.
Thank you for your help.