Probe Calibration using VQC = Error 337 - GOTO OR P LINE NOT FOUND

[XxLT250RxX]

I am trying to calibrate the Renshaw probe on a VF1 using VQC and getting error 337 or GOTO OR P LINE NOT FOUND. I am using a ring gage and it goes through the cycle as it always has but gives this error at the end of the cycle. The length calibrated fine.

Similar Threads:

• Problem- Error in IF, GOTO statement. LC40 OSP5000
• Calibration of cylinder probe
• ?? Probe lost calibration ??
• Probe calibration
• Need Help!- Work Probe Calibration

[bronec]

I am trying to calibrate the Renshaw probe on a VF1 using VQC and getting error 337 or GOTO OR P LINE NOT FOUND. I am using a ring gage and it goes through the cycle as it always has but gives this error at the end of the cycle. The length calibrated fine.

The "GOTO" command in the macro program is incorrect.

[haastec]

I am trying to calibrate the Renshaw probe on a VF1 using VQC and getting error 337 or GOTO OR P LINE NOT FOUND. I am using a ring gage and it goes through the cycle as it always has but gives this error at the end of the cycle. The length calibrated fine.

I would try reloading your Renishaw macro programs. Hopefully you have a backup copy, if not contact your dealer and they should be able to email you a copy.

[XxLT250RxX]

I would try reloading your Renishaw macro programs. Hopefully you have a backup copy, if not contact your dealer and they should be able to email you a copy.

Thanks, that fixed it.