Originally Posted by
pontiacg5
I have a 2000 SL30 with quite a few problems, the 115V for triggering solenoids and relays is not passing through the I/O board like it is supposed to.
I have measured 3 phase 115V at P56 at the I/O board, but I'm not getting 115V out when I should be. The most apparent problems are the hydraulic pump and the servo brake circuit, but the air solenoid for the turret is not working either.
I have ordered a second I/O board off ebay, the guy who sold it said it worked but after the fact said this "new" I/O board is actually used, he just sold us his old probably broken one and swapped a new replacement onto his lathe. He mentions something about fuse F13 being the problem, there is no F13 in this SL30. I have power everywhere I should at the power distribution board.
Not really sure what I expect for help, Haas can't even get schematics for the I/O board and of course the processor board is EOL and serious $$$.
Has anyone experienced a problem like this before, and if so how did you get it fixed!
Thank you!