| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Granite Devices Discuss about servo & stepper drives made by Granevices and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-12-2008, 07:18 PM
| |||
| |||
My mill had three inductors connected to the drives. Looking at the servopack pdf they were in series with the motors. They are 3mH 11A inductors.  Motors are:UJMED 60L[and 80M], these are Minertia J motors[yaskawa] Drives are: CPCR MR 154 I mentioned the inductors when I last mailed Tero. Will I need them with the Granite drives?    |
|
#2
12-12-2008, 07:35 PM
| ||||
| ||||
| It depends what the minimum inductance requirements are for the drives, I always tend to include them if they are already fitted, so far without detrimental performance on the drives I use. Al.
__________________ “Logic will get you from A to B. Imagination will take you everywhere.” Albert E. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- INDUCTORS FOR MOTORS | GARG69 | General Electronics Discussion | 1 | 05-15-2008 10:55 AM |
| Soldering to copper foil inductors | martinw | General Electronics Discussion | 5 | 08-18-2007 02:25 PM |
| Inductors with Rutex Drives | MMT | Servo Drives | 4 | 03-13-2005 05:59 PM |
| | |
Linear Mode
