| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Granite Devices Discuss about servo & stepper drives made by Granevices and get direct support! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-27-2010, 08:22 AM
| |||
| |||
The drive is currently set up for a brushed DC motor driven by step/dir input. The Fault signal comes thru on both out1 and out2, so I am sure the outputs are powered and working, but I cannot get a state change on either output with the 'Target Reached' signal assigned to either output. I have double checked all of the settigns as suggested by Granite support, but the feature is still not working. Is there anyone using the 'Target Reached' signal successfully on any outputs of the VSD-XE?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Evaluation Reached | brouser1 | SheetCam | 1 | 04-16-2010 12:21 PM |
| Rhino output doesn't work... | saturnnights | SheetCam | 9 | 02-14-2006 11:48 AM |
| Minimum speed of spindle reached | WarrenW | Mach Software (ArtSoft software) | 1 | 11-21-2005 06:29 PM |
| over shooting of target coordiniate then stepping back | polytone | Gecko Drives | 6 | 05-28-2005 06:44 PM |
| Keeping Men On Target | WallCrawler | CNCzone Club House | 2 | 05-21-2004 09:37 PM |
| | |
Linear Mode
