| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Gorilla CNC Machines Discuss Gorilla CNC Machines here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-05-2009, 05:34 PM
| ||||
| ||||
This plate is 11x11x.75 thick was done in 5 toolpaths and 3 bit changes and had to flip the material once . The file came from http://www.vectorclip3d.com a company in quebec,its quite a compliment to me ,but really i enjoyed the cut and the machine was really ramped up speed wise ,i did slow it down on the first backside cut as it was cutting a lot of wood out towards the outside of the dish. Its wet looking because i just did it and slapped a stain on it ,should have left it raw for my salad    |
|
#2
09-06-2009, 12:38 PM
| |||
| |||
Hi All see the video for making your personalized plate with our pre-programmed toolpath Good luck for your project Norbert Dupuis http://www.vectorclip3d.com |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Any tips for designing a fixture plate / tooling plate? | thackman | Benchtop Machines | 9 | 12-19-2008 12:26 PM |
| HSS Plate | Yossi | General Metalwork Discussion | 0 | 07-19-2007 09:55 AM |
| Aluminum: flat, bar, sheet, plate, tooling plate?????????? | Dan S | DIY-CNC Router Table Machines | 12 | 06-28-2007 01:48 AM |
| 410 & 420 SS plate | AMCjeepCJ | Mass finishing equipment/media/stratigies | 0 | 03-31-2006 11:09 PM |
| Tooling plate or sub-plate | drill | General CNC (Mill and Lathe) Control Software (NC) | 3 | 02-02-2006 03:17 PM |
| | |
Linear Mode
