re-surfacing the cnc table top

[woodman08]

It was time again to re-surface or level out the table top .This time i took it down 1/8 inch ,everything went well it took about 1.15 hrs ,i could have ramped up the speed but i kept the router amps about 8.78 to 9.10 amps and used a 1.50 carbide bottoming bit with a 45% step over
Table looks good now ,all the nail and screw marks are almost gone but its flat and smooth


"http://www.youtube.com/watch?v=797cvxfdDK4"]YouTube - cnc table re-surfacing