3rd cedar tool_plaque

[woodman08]

"http://www.youtube.com/watch?v=Ami_hUBZq80"]YouTube - tool plaque

took about 1.50 min 17in dia 4 toolpaths 3 bits used some clipart put all together in corel printed ,then hand edited (some incomplete lines) scanned it into corel again saved the file as *.bmp then put into aspire
Did ok would delete or cut back on one tool path as it was 65% in the air

[GaryCorlew]

Looks Nice, You may want to try a down cut sprial bit you will have almost no clean up after

[woodman08]

you are right but a few passes on the table top sander fixed all of that