Results 1 to 1 of 1

Thread: tracing parts out for cnc

  1. 12-29-2011, 05:00 PM #1
    woodman08
    woodman08 is offline
    Registered woodman08's Avatar
    Join Date
    Oct 2007
    Location
    canada
    Posts
    465
    Downloads
    0
    Uploads
    0

    tracing parts out for cnc

    from a drawing to a dxf format
    for cutting

    from a part to dxf format

    cardboard template to dxf
    the table and pen are connected via serial output
    Attached Thumbnails Attached Thumbnails tracing parts out for cnc-herron.jpg   tracing parts out for cnc-table_setup.jpg   tracing parts out for cnc-table_setup2.jpg   tracing parts out for cnc-serila.jpg  


« Another router bites the dust | more tracing using software and a pen »

Similar Threads

  1. tracing using a digitizer pen
    By woodman08 in forum General CAD Discussion
    Replies: 3
    Last Post: 06-30-2011, 07:48 PM
  2. Tracing?
    By Joe Petro in forum TurboCAD/CAM
    Replies: 4
    Last Post: 11-02-2007, 08:19 PM
  3. Tracing Logo's in CAD
    By tikka308 in forum General CAM Discussion
    Replies: 15
    Last Post: 10-10-2007, 10:17 AM
  4. Tracing eye and MACH 3
    By DSL PWR in forum Mach Plasma / Laser
    Replies: 4
    Last Post: 08-17-2006, 09:37 AM
  5. Tracing a picture in CAD
    By DennisCNC in forum General CAM Discussion
    Replies: 21
    Last Post: 05-15-2006, 06:32 AM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.