2nd run at stair tread grips


Results 1 to 1 of 1

Thread: 2nd run at stair tread grips

  1. #1
    Member woodman08's Avatar
    Join Date
    Oct 2007
    Location
    canada
    Posts
    1010
    Downloads
    0
    Uploads
    0

    Default 2nd run at stair tread grips

    With aspire 9.010 went at the stair tread trying to cut down the machine time and also adding a reverse type cut or climb vs conventional hoping to clean
    up the cut from the V90 bit as different wood grains act differently when machined (shredded looking)
    The time has been cut a lot , but I had to do the 2 runs climb and conventional and the wood looks 99% better
    looks like these can be done at less than 10 min


    second run

    Similar Threads:
    Attached Thumbnails Attached Thumbnails 2nd run at stair tread grips-one-jpg   2nd run at stair tread grips-three-jpg   2nd run at stair tread grips-two-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

2nd run at stair tread grips

2nd run at stair tread grips