Paul,
Do you mean turning?
If so Positive.
What is the best bit for turning Delrin? Positive or negitive rake etc ..?
Last edited by CNCadmin; 02-13-2004 at 11:05 PM.
Thank You,
Paul G
Site Owner-Webmaster-
Administrator
www.rfqwork.com
www.cnczone.com
www.welderzone.com
Paul,
Do you mean turning?
If so Positive.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Yes that's what I mean, ok thanks for the answer.
Thank You,
Paul G
Site Owner-Webmaster-
Administrator
www.rfqwork.com
www.cnczone.com
www.welderzone.com
Go here http://www.cncplastics.com/PDFs/Mach...l%20Delrin.pdf for detailed info on machining Delrin. Other great info available at www.cncplastics.com (http://www.cncplastics.com) in the physical properties section.