| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Glass, Plastic and Stone Discuss machining Glass, Plastic and Stone here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-28-2011, 08:30 PM
| |||
| |||
I have been making a bike part for a friend using abs that I would like to give something of a matte finish. I have a vibrator/tumbler unit and the ceramic harbor freight chunks (97027) I was using don't seem to be doing much (although they did an ok job deburring the sharp points). perhaps that's because they are intended for polishing... hmm wish it said that on the container so I knew when I bought it  They are headed off this weekend so I'm looking for another media I can find locally at a hardware store before reverting to scotch-bright pads. Lava rocks, gravel, Any suggestions?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tumbler or Vibrator for finishing parts. | TXFred | Benchtop Machines | 82 | 05-04-2012 06:06 PM |
| Need Help!- What anodizing method for matte finish? | Luis Van Damme | Metal Finishing and Plating | 0 | 09-02-2011 05:03 PM |
| Tumbler media needed | thedave | General Metalwork Discussion | 2 | 06-06-2010 10:54 PM |
| Homemade bowl tumbler, media for Al polishing | bob1112 | Mass finishing equipment/media/stratigies | 4 | 03-27-2007 02:15 AM |
| Aluminum Matte Finish | Tazzer | General Metalwork Discussion | 3 | 04-13-2004 10:31 AM |
| | |
Linear Mode
