Mitsubishi Post - CNCzone.com-The Largest Machinist Community on the net!

projay · #1 02-19-2008, 01:39 PM

Hi, i need a post for a Mitsubishi Medals 500, 4 axis Horizontal, using Gibbscam. I have a few post, I'm willing to trade.

shanepeed · #2 05-20-2008, 04:03 PM

I have a couple of posts for my NH4000 Mori I sold that might work for you that I used when I was programming it with Gibbs. I also am looking for a Fanuc OT post for my Gibbs.

clive107 · #3 06-03-2008, 04:24 AM

Hi all,
new to site so please be pateint. I am looking for a manual for a mistsubishi controller.
The machine is a leadwell MCV-760AP and the controller is a MB952B. I am getting a servo alarm on the y axis but without the manual I am unable to determine where the fault is origonating form. Any help would be appreciated.

Many thanks

clive

burgerboy · #4 10-26-2008, 07:05 PM

Willing to trade some post

Here is mine below.....

http://cnczone.com/Gibbscam_Post/

shanepeed · #5 10-27-2008, 05:36 PM

Originally Posted by burgerboy

Willing to trade some post

Here is mine below.....

http://cnczone.com/Gibbscam_Post/

Send me your email and I will send you what I have

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Gibbs post for Mitsubishi	kz1670	Post Processor Files	4	01-14-2008 07:21 PM
Mitsubishi Post	rick_roland	Post Processor Files	0	04-16-2007 04:31 PM
post processor needed for mitsubishi wire	rick_roland	Post Processor Files	0	04-16-2007 12:58 PM
CH-VMC 500-Mitsubishi 60S	thanhct	CNC Machining Centers	5	04-02-2007 02:49 AM
post processer Mitsubishi control	bala955	Daewoo/Doosan	0	12-23-2006 11:45 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)