posthaste help - CNCzone.com-The Largest Machinist Community on the net!

tman66 · #1 02-13-2008, 02:22 PM

Hi All,

Trying to modifiy a haas hl series lathe posthaste post to a sl series. My trouble seems to be it will not put any drill cycles at all. Is it Gibbs or post haste? Can someone steer me in the right direction? You can see the problem on ops 4,5, and 6.

Thanks
Roger

tman66 · #2 02-13-2008, 06:17 PM

Anybody? Does anyone have a haas sl lathe post?

cadman · #3 02-14-2008, 08:41 AM

Is your template modified correctly? Could you output canned cycles before you modified it? I believe there was an issue with Posthaste and lathe canned cycles that was fixed recently. Contact Ground Support and they may have an updated dll.

tman66 · #4 02-14-2008, 08:44 AM

Cadman, thanks for the reply. I just saw the post that said they had a "bug" in it. Going to contact Paul about the problem.

projay · #5 02-19-2008, 11:34 AM

Hi,

I'm a new member, this site looks promising. I have some SL post. give them a try!
I'm also looking for a post for a Mitsubishi Medals 500 can anyone give me a hand with that?

tman66 · #6 02-19-2008, 01:04 PM

Thanks Projay!! Owe you a beer or two!!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
PostHaste post editor	naytep	Post Processor Files	9	09-11-2010 05:20 PM
posthaste	kazmir44	Post Processor Files	1	01-08-2008 08:41 AM
Posthaste Question	microdot	GibbsCAM	3	11-26-2007 06:53 PM
PostHaste Software	hancockj	Post Processor Files	0	10-26-2006 04:58 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)