Lathe drilling canned cycle - CNCzone.com-The Largest Machinist Community on the net!

cijunet · #1 12-05-2007, 08:18 PM

Hi all,
I'm drilling a part on the lathe, but "Preferred canned" option is grayed out. Any idea why?

daewooevc · #2 12-06-2007, 06:25 PM

Do you have auto clearance selected?

cijunet · #3 12-07-2007, 09:10 AM

Thank you for the reply!
Looks like here is no such option in drilling tile....
I attached a screen shot that can give you a better idea of what I'm looking for.
Thanks

daewooevc · #4 12-07-2007, 08:37 PM

In the Document Control Dialog. Directly below where you set your stock size.

cijunet · #5 12-08-2007, 04:38 PM

Thank you. It works now.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
canned cycle for lathe with fanuc control	JPann	G-Code Programing	6	09-27-2011 12:45 PM
Canned drilling cycle on 0TB	guhl	Fanuc	0	11-22-2007 06:33 AM
Canned cycle output in Gibbs lathe	naytep	GibbsCAM	2	08-30-2007 02:38 PM
Daewoo puma 12L fanuc ot drilling canned cycle	burnin daylight	G-Code Programing	6	08-27-2006 05:26 PM
canned drill cycle	nitrosnfr	General Metalwork Discussion	2	05-24-2006 10:50 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)