Help with Mill bore process...

[tomekeuro85]

When I make a finish mill bore process to make a bore with an end mill, the tool goes down into the hole, and then does a G00 rapid movement to the edge of the hole..

Is there a way to avoid this? It makes me uncomfortable to have the tool do rapid movement inside of a hole, even though the chance of collision is very small.

Does anyone know how to change this to do G01 only?

Thanks in advance

[cadman]

Open the process tile, go to the Bore tab, enter 0 in the Clearance Amount box and the tool will feed from the center.

The number you enter here is the clearance diameter the tool will rapid to and start it's feed.

[tomekeuro85]

Thanks a bunch, just what I needed.

We just got gibbs about a month ago so i'm still learning the final small details of stuff... overall its pretty easy to use though.