Turn off Subroutines in Gibbs 2015

[Sierevello]

I have an older mill that is limited to 999 lines of code (Anilam Crusader M). I have it set up to drip feed, but the problem I just ran into is that when drip feeding it only reads the first 500 lines of code/ executes them and downloads 500 more. It gives me a subroutine error b/c it cannot locate the subroutine b/c it is at the end of the program that has not been downloaded yet. I see the check box for "minimize subroutines", but is there somewhere I can check to disallow the use of subs and just get the hard code?


Thanks for any help,
Steve

Similar Threads:

• Gibbs 2015 Post
• 2015 Mill Turn
• New 2015 Shopmaster Mill-Turn

[ajesms]

You need a post that not ouput subs. Is possible find it in gibbscam support or i could do it


Enviado desde mi iPhone utilizando Tapatalk

[Sierevello]

Thank You! Let me know where to send the current post with subs and how I can compensate you.

-Steve

[mactec54]

I have an older mill that is limited to 999 lines of code (Anilam Crusader M). I have it set up to drip feed, but the problem I just ran into is that when drip feeding it only reads the first 500 lines of code/ executes them and downloads 500 more. It gives me a subroutine error b/c it cannot locate the subroutine b/c it is at the end of the program that has not been downloaded yet. I see the check box for "minimize subroutines", but is there somewhere I can check to disallow the use of subs and just get the hard code?


Thanks for any help,
Steve

When you go to post your program, check the minimize sub box, this should take care of it

[Sierevello]

Mactec,

I tried that and still got 1 subroutine.

Thanks,
-Steve

[ajesms]

Mail inbox full sierevello


Enviado desde mi iPhone utilizando Tapatalk

[Sierevello]

Sorry ajesms... I emptied it. You can send it now.

Thanks,
Steve

[mactec54]

Mactec,

I tried that and still got 1 subroutine.

Thanks,
-Steve

Make sure Prefer Subs is not checked in any of the processes

Also under Preferences you can uncheck the Sub Number

A sub still may happen with Thread milling, but that is easy to edit and remove it

[markp]

Marce, Hi can you please finish the gibbs post for my DMU50V?

Mail inbox full sierevello


Enviado desde mi iPhone utilizando Tapatalk