Originally Posted by
Sierevello
I have an older mill that is limited to 999 lines of code (Anilam Crusader M). I have it set up to drip feed, but the problem I just ran into is that when drip feeding it only reads the first 500 lines of code/ executes them and downloads 500 more. It gives me a subroutine error b/c it cannot locate the subroutine b/c it is at the end of the program that has not been downloaded yet. I see the check box for "minimize subroutines", but is there somewhere I can check to disallow the use of subs and just get the hard code?
Thanks for any help,
Steve