Need post for Fanuc OM control for G76 Fine Boring

[laka]

I have a bunch of Fanuc OM posts, and have tried everyone of them and none of them will output G76 for a Fine Boring cycle (tool shift retract.) Was wondering if anyone had one that would work? Or if im missing a setting or something in Gibbs.

thanks!

[txcncman]

Check this thread:

Virtual Gibbs Post Needed

[laka]

I have the same database of post's and couldn't find any that would post a G76 for me. Do you know how to edit the TXT file to produce a new post file that would do this?

[txcncman]

This one was included and says it has G76 added. Did you try it?

[laka]

Just tried that one and no luck. I have "Fine Bore" selected with a 0.030" pull-off and this is what gets posted.

G85G99X3.Y-3.Z-.5R.25F20.
G80

[txcncman]

Which version of Gibbs are you using?

[txcncman]

Try this one, it posts G76. It is for the 11M though. But then you should be able to find the correct lines to modify in your post.

[laka]

2010 9.5.1